S
COOP
W
AVE
S
LIDE
I
NSTALLATION
A.
Center the Scoop Wave Slide in a standard opening.
Make sure the upright mounting face of the slide is
pushed against the Tower. Insert 1 — 4¼” lag bolt
from the Scoop Wave Slide Hardware Pack
(packaged
separately)
into each of the two holes in the upright
mounting face. This should securely anchor the slide
against the Tower.
A
CCESSORY
I
NSTRUCTIONS
W
AVE
S
LIDE
I
NSTALLATION
Center the Wave Slide in a standard opening. From outside the Tower make sure that
the slide is not incorrectly angled to the right or left. Fasten the slide to the deck us-
ing 4 — Slide Screws. Insert the longer screws through the deck and into the floor
frame 2x4 without washers. Place washers on the shorter screws and insert them
through the pre-
drilled holes of the
slide into the deck.
Do not over
tighten these
screws. They can
easily strip out
and not hold. No
fastening is re-
quired at the bot-
tom of the slide.
B.
Use the remaining screws and washers from
the Scoop Wave Slide Hardware Pack to
fasten the slide to the deck as pictured at
left. Do not over tighten these screws. They
can easily strip out and not hold. No fasten-
ing is required at the bottom of the slide.
Summary of Contents for Watch Tower
Page 1: ...Watch Tower Assembly Instructions...
Page 20: ......