15
Turning the Unit On/Off
Turn Unit On
▪
Press the POWER button to turn the unit ON.
▪
The Snap Shot™ immediately runs a length test when powered ON.
Turn Unit Off
▪
Press and hold down the POWER button for two seconds to turn the
unit OFF. The display screen goes blank.
Automatic Power Down
The Snap Shot™ automatically turns off after a period of inactivity to
conserve battery power. The automatic power down feature is dependent
on which mode is in use and if voltage is detected on the cable being
tested (see Table 9).
Table 9.
Automatic Power Down.
Operations
To ensure safe operation of the Snap Shot™, follow the instructions
carefully and pay attention to the warning and caution symbols. Failure
to observe warnings can result in severe injury or death and can damage
the unit.
Mode
Time
Test Mode
1 minute
Loop Testing
3 minutes
Tone Mode
15 minutes
Calibration Mode
1 minute
