20
21
Link Light
The Link Light test is used to help identify a hub or switch port.
y
Power on the Net Prowler.
y
Connect the Net Prowler to an active Network cable or port.
y
Press the Network/PoE soft key
then press the Link Light
soft key
.
y
The Link Light will automatically begin upon entering the Link
Blink menu.
y
The Link LED above the LCD screen will flash at the same cadence
as the port light.
y
Use the up and down arrows to adjust the transmit frequency to suit
the switch characteristics.
Tone Generator
Tone generation is used to trace cable runs and locate faults by sound.
Selection of this mode emits a cadence from the Net Prowler through the
connected cable. The tone is detected by a tone tracer probe.
• Power on the Net Prowler.
• Use the left or right arrow buttons to select the tone generator
icon and press the enter button.
• The Net Prowler will automatically activate the tone generator
upon entering the tone generator menu.
• Connect your cable to either the RJ45 jack or coax connector located
on the top of the Net Prowler.
• To switch between network and coax cables, press the coax cable/
RJ45 soft key
/
.
• Press the up or down arrow buttons to select tone cadences 1 thru 4.
• Press the left or right arrow buttons to select which pin or pair to
place the tone.
• Use a tone probe alongside the cable or at the end of the cable to
hear an audible tone.
