10
TECHNICAL SUPPORT: (909) 259-6001
ACTP715
Mounting Instructions
STEP 1
Position Back bracket on to the pilar, check
installation measurements and secure it. The
installation measurements indicated in the
table on page 9 allow you to choose the
values of [A] and [B] on the basis of the
desired opening angle and in relation to the
on-site spaces and overall dimensions.
Note:
For an open outside gate, an additional
bracket will need to be fabricated to obtain the
proper configuration (see figure on page 10).
STEP 2
Position Front bracket to the gate. Make
sure Front and Back brackets are
perfectly level.
STEP 3
Remove the Terminal Cover by opening the
lock flap and removing the screw.
CAUTION
Check that the structure is sufficiently rugged and that the hinge pivots are
properly lubricated.
ACTP715 Manual_Layout 1 11/4/2014 3:53 PM Page 12