LiteScout
®
User Instructions
7
7.
Technical Data for Converter Module CM-PL 025 E
Input
100 - 240 V AC, 50 / 60 Hz
140 - 250 V DC
45W max.
Output
0 - 150 V AC eff., 200 - 800Hz
40W max., 100VA max. (effective power)
Galvanically isolated
yes
Output current
Electronically limited, protected against
short circuits and open-loop operation
Overload display
Red warning lamp (LED)
Integrated programs
7 effects: blinking, flashing, sine wave,
positive/negative sawtooth, triangular
wave, irregular
External analog interface
0-10 V, e.g. light control board, PC-Interface
Maximum light surface
2.500 cm
2
(approx. DIN A2 size, minimum DIN A5)
of the LiteScout
®
Housing
Aluminum top and plastic side covers
Dimensions (L x W x H)
180 x 80 x 40 mm
Certification
TÜV-certified (TÜV/GS-mark) and CE
Last updated: November 2005
Pos. 1
Pos. 2
Pos. 3
Pos. 1
Pos. 2
Pos. 3
It is possible to operate the LiteScout
®
with the
converter module controls at their maximum set-
tings (Pos. 3). However, running the system at very
high operating parameters will reduce the life of
the LiteScout
®
. Therefore, we recommend that you
keep the settings on new units at or below Pos. 1.
The LiteScout
®
light sources age with use, and their
brightness eventually wanes. You can counteract
this aging process by increasing the voltage and
frequency settings on older units to Pos. 2 and later
to Pos. 3.
IP 20
Settings
User Intructions/LiteScout.qxd 06.12.2005 14:33 Uhr Seite 4
