LiteScout
®
User Instructions
4
2.
Operating Controls for Converter Module CM-PL 025 E
The converter module CM-PL 025 E is the power supply unit you’ll use to operate
the LiteScout
®
. An explanation of the labels on the converter module CM-PL 025 E
is given below (see figure).
• On/off switch (1)
• Red warning light (2): Error! This light comes on when there is a problem with the unit.
• Voltage control (3): Sets the operating voltage to 0-150 V AC.
• Frequency control (4): Sets the operating frequency to 200-800 Hz.
• Speed control (5): Sets the speed for effect programs 1-7.
• Effect control (6): Selects effect programs 1-7
• Electric cord with plug (7)
• Connector socket for LiteScout
®
(8)
• External analog interface (9) – controls dials (3-6):
for 0-10 V light control board or other accessory
(remote control)
3.
Initial Operation of the LiteScout
®
Take the cord extending from the LiteScout
®
and plug the connector into the
connector socket (8) on the converter module. To lock the connector into the socket,
turn the ring on the connector clockwise, and the connector will tighten. This makes
it impossible to pull the cable out of the converter module.
Once the connector is secured in the socket, make sure that all four controls (3-6) on
the converter module are set to »Minimum,« i.e., turned all the way to the left. Then
plug the electric cord (7) into the wall and switch the converter module on (1).
Voltage (3)
Frequency (4)
Speed (5)
Effects 1 - 7 (6)
Error (2)
Connector socket (8)
External analog interface: for 0-10 V light control board or other accessory (9)
On/off switch (1)
Electric cord with plug (7)
User Intructions/LiteScout.qxd 06.12.2005 14:33 Uhr Seite 7
