Pipeline installation
P
roduct
installation
a) Open a
130
*
130mm
port on the pipe surface.
b) Use scissors or a metal plate cutter to cut the marked area
c) Align the flange washer and use self-acting screws to fix the device to the pipeline.
1. If it cannot be installed in the preferred location due to space constraints, please
refer to the alternate location shown in the figure below.
2. Select a location with good air flow in the air handling unit.
3. Connect the power supply, the indicator light is on, and the number of ions can be
adjusted in 1, 2, and 3 gears.
Installin fan coil
1. Check whether the product is intact before installation and run the test with power
on. If damaged during transportation, please contact customer service in time.
2. This product should not be installed in a place where the air temperature exceeds
60°, preferably in a location with smooth ventilation.
Pipe
cut
size
Horizontal hole pitch: 1
52
mm
Vertical hole distance:
152
mm
Pipe shear opening range:
130
*
130
mm
1. Make sure that the product is hanging
on the wall before installation The distance
of the hole marks the position where the
hole needs to be punched.
2. Use a drill to drill holes at the marked
locations.
3. Put the product pipe first at the opening
of the pipe shearPlace it in balance.
4. Then align the holes with holes and
screw them in.
130mm
152mm
152mm
152mm
130mm
130MM
130MM
(a)
(b)
(c)
