5 System description
The Planmeca PlanMill 50 S is a milling unit intended for the production of
dental indications and has been specially developed to satisfy the
requirements of the dental industry. The Planmeca PlanMill 50 S is not
suitable for the application of conventional milling techniques. The Planmeca
PlanMill 50 S is suitable for both for dry and wet processing using the
materials listed in section "Materials" on page 21.
The tool magazine can be equipped with up to 12 tools and the milling unit
kinematics enable simultaneous processing in 5 axes.
5.1 Materials
The following materials can be processed with PlanMill 50 S milling unit:
•
Zirconium dioxide
•
Aluminium oxide
•
Plastics
•
Wax
•
Peek
•
Prefabricated CoCr abutments
•
Prefabricated Ti abutments
Work pieces suitable for Planmeca PlanMill 50 S, in disk sizes 98mm and
98,5mm and blocks in different sizes from the materials listed above, are
available from Planmeca. Other materials are available on request and
require the express approval of Planmeca.
NOTE
Before using other materials!
Processing other materials is prohibited and requires separate approval and
permission from Planmeca. For further information please contact your local
dealer.
5.2 Cooling liquid
Only use cooling liquid from Planmeca. The mixture ratio can be found in the
cooling liquid description. For further information regarding handling and
disposal, refer to the separate safety data sheet, which you can request from
the Planmeca customer service at any time.
•
Cooling liquid 1000ml (10036920)
5.3 Milling tools
The tools approved by Planmeca for use in the Planmeca PlanMill 50 S
milling unit are listed in the table below.
WARNING
If unapproved tools are used there is a risk of serious injury and substantial
damage.
Please contact the Planmeca customer service department for the approval
of other tools.
5 System description
User's manual
Planmeca PlanMill 50 S 21
