17
I
III
II
REPLACING FUEL CONTAINER
1.
If the fuel container is empty (
), unscrew the cap with the pumping hose and remove the container from the
holder (
) (I).
2.
Insert a full fuel container with a cap removed (
) (II).
3.
Screw the cap with the pumping hose back on (III).
FLAME IGNITION
The green diode
indicates that the device is ready to ignite the flame.
Press and hold
START
for 3 seconds. Flame ignition will take 2-10 minutes (
). The smell of ethanol vapours can be
present during the ignition. The diode
READY
off (
) indicates that
the flame has been ignited and the device
reached the working temperature.
FLAME HEIGHT REGULATION
After 3 min, press
ECO
to lower the flame (two sound signals). Press
ECO
again to increase the flame height (one
sound signal).
ATTENTION!
In case the device temperature is too high, the flame will be automatically lowered (
ECO
) and the height
regulation blocked. If the temperature keeps increasing, the device will be turned off.
FLAME EXTINGUISHING
Press
STOP
to extinguish the flame (sound
).
You can ignite the flame again when the device is cooled
– the green diode
READY
(
).
FAST START
The
FAST START
offers faster flame ignition . The function is enabled by default.
To disable
FAST START
, press and hold
ECO
for 10 seconds (four sound signals). To enable the function, press
and hold
ECO
for 10 seconds (two sound signals).
EN
GL
ISH
Summary of Contents for Pure Flame
