Select the transmission rate for the network.
Beacon Interval
(20 – 1000)
Beacons are packets sent by an Access Point to synchronize a wireless network. Specify a
Beacon interval
value. Default (100) is recommended.
DTIM (1 - 255)
Enter a value between 1 and 255 for the Delivery Traffic Indication Message (DTIM.)
DTIM
is a
countdown informing clients of the next window for listening to broadcast and multicast
messages.
Fragment Length (256 – 2346)
This value should remain at its default setting of 2346. If you experience a high packet error rate,
you may slightly increase your Fragmentation Threshold within the value range of 256 to 2346.
Setting the Fragmentation Threshold too low may result in poor performance.
RTS Length (256 – 2346)
This value should remain at its default setting of 2346. If you encounter inconsistent data flow,
only minor modifications to the value range between 256 and 2346 are recommended.
Transmit Power
Transmitting power can be limited for circumstances where cell overlap is not desired or
interference is a concern. The options are full (default), half (–3dB), quarter (-6dB), eighth (-9dB)
or min (minimum).
Super G Mode
If your Wireless LAN Card supports Super G Mode transmit rate. You can use this function to
increased wireless throughput.
802.11g Only
Enable this function only support IEEE 802.11g mode wireless transmission.
Radio On/Off
Choose the Wireless Radio On to receive the radio frequency signal. Or choosing the Wireless
Radio Off will stop receiving the radio frequency signal.
Click
Apply
if you have made any changes or additions.
