User’s Manual of WGR-500-4P and WGR-500-4PV
22
Step 2:
Install a conductor pipe inside the board hole and flush the edge of the conductor pipe with the wall
surface.
Step 3-1:
Screw the bolts into the conductor pipe. The industrial wall-mount Gigabit router is between bolts and
conductor pipe as shown in
Figure 2-12
.
Figure 2-12:
Router is screwed to the wall
Step 3-2:
Insert screws into the wall anchors, leaving 2mm of each screw exposed. Place the wall-mount slots
over the screws and slide the device down until the screws fit snugly into the wall-mount slots. The
industry router can be hung on the wall as shown in
Figure 2-13
.
Figure 2-13:
Router is hung on the wall
