3. Be noticed, there are 2 ways for RJ45 cable connector avoiding water or thunder
stoke.
a. Stick and bind with rubber mastic tape on RJ45 cable connector after
connecting cable to “P+DATA OUT” port of PoE Injector.
b. After connecting cable to “P+DATA OUT” port of PoE Injector, open the Back
Cover and put the RJ45 cable connector inside of Back Cover, then plug the
Back Cover to CPE Set for preventing water.
4. Using Category 3 or higher UTP or STP cable, connect the “DATA IN” port of PoE
Injector to a 10Mbps or 10/100Mbps Ethernet hub or switch, and connect the PC
on the same LAN for management.
Note
To avoid thunder strike, consider to install ELA-100, thunder
arrester toward the CPE AP and the PoE injector.
5. Connect the power cord to the PoE Injector, and plug it into an AC outlet to
power on the WAP-6200.
Note
1. ONLY use the power adapter supplied with the WAP-6200.
Otherwise, the product may be damaged.
2. Strongly suggest using SFTP cable whether the cable exposed
outdoor for waterproof and avoiding thunder stroke.
RJ45 CABLE
BACK COVER
FRONT COVER
CPE SET
POLE 1”-~1.5”
Mouting Kit
