WAP-1000 User’s Guide
3
Chapter 2 Hardware Installation
2-1 System Requirements
Installation of WAP-1000 requires:
1.
An A/C power outlet (100~240V, 50~60Hz) which supplies the power for WAP-1000 Access
Point.
2.
A 10Base-T (UTP) Ethernet cable drop (RJ-45 connectors).
Note:
(
Only if you want to re-configure the WAP-1000 Access Point instead of using factory
installed default configuration…
) A DOS-based PC with TCP/IP connection to the network
or with an available RS-232C port to run the configuration program.
2-2 Mechanical Description
Front Panel:
Side Panel:
Fig2-1 Mechanical Instruction of WAP-1000 Access Point
2-3 WAP-1000 Hardware Installation
Please follow these procedures for setting up hardware:
1.
Site Selection
Choose a proper placement for your WAP-1000 Access Point. The Site Survey and Access Point
Browser utility will help you with site selection.
In general, the best location to place your WAP-1000 Access Point in your site is the center of
RS-232C Configuration Port
Antenna Connector
Power Switch
DC 5V Power Socket
RJ-45 Connector
: Power
: (Wired) Ethernet Tx/Rx
: Wireless LAN Tx/Rx
