19
4.3 Chassis Installation and Rack Mounting (VC-231)
To install the Ethernet over VDSL2 Bridge in a 10-inch or
19-inch Converter Chassis with standard rack, follow the
instructions described below.
Step 1:
Place your VDSL2 Bridge on a hard flat surface, with
the front panel positioned towards your front side.
Step 2:
Carefully slide in the module until it is fully and firmly
fitted into the slot of the converter chassis.
Step 3:
Attach a rack-mount bracket to each side of the
Converter Chassis with supplied screws attached to the
package.
Step 4:
After the brackets are attached to the Converter
Chassis, use suitable screws to securely attach the
brackets to the rack.
Step 5:
Connect one end of the power cable to the
10-inch
or
19-inch
Converter Chassis.
Step 6:
Connect the power plug of the power cable to a
standard wall outlet, and then power on the 10-inch or
19-inch Converter Chassis. The PWR LED should be lit.
Caution
You must use the screws supplied with the
mounting brackets. Damage caused to the parts
by using incorrect screws would invalidate your
warranty.
Summary of Contents for vc-231
Page 1: ...Ethernet over VDSL2 Bridge VC 231 VC 234 User s Manual ...
Page 27: ......
Page 28: ......
