Planet POE-100, User Manual

Page: 16 / 19

12 13
Appendix B
Frequently Asked Question
1. What’s the correct step to apply the power to the remote
device?
Ans:
a. Please make sure the POE-100S is set to the correct DC
output voltage in advance.
b. Connects the remote device to POE-100S, both power
plug cable and Ethernet cable
c. Plug-in the 15VDC power to the POE-100 and check the
LED on it.
d. Plug-in the UTP cable from POE-100 into the “Ethernet
+ DC” port of POE-100S. The LED on POE-100S should
turns on. And the remote device starts to boot up
e. IF you would like to change the voltage, please DO re-
move the cable from the port “Et DC” of POE-
100S. Make sure the LED of POE-100S is turned off to
adjust the voltage output.
2. How many remote Ethernet devices can be powered?
Ans:
a. Due to POE-100/100S only provide one Ethernet inter-
face, only one Ethernet device can be powered.
b. For safety reason, POE-100/100S will only support device
with power consumption below 12watts. Please make
sure the remote Ethernet device is under the range of
12V 1A, 7.5V 1.5A or 5V 2A, that with power consump-
tion below 12 watts.