2.1 Assemble of the Hard Disk Drive
1. Extract the plastic upper frame by sliding it out the gape on the top of the case.
2. Unfasten the screw on the lower part of the front cover. Remove the front cover by lifting the clip with a flat screw
driver.
3. Place the device horizontally; align the hard disk drive with the PCB board. Push slowly and gently to the most inside
until the hard disk drive is firmly seated.
4. Assemble the enclosure by fastening the screws on both top and bottom sides.
5. Attach the front cover to the case and secure the screw on the lower part.
6. Restore the plastic upper frame by sliding it into the gape on the top of the case. Make sure the plastic upper frame
matches the direction.
3
