Planet MAP-3020, Web Management Manual

Page: 38 / 97

Page 38 of 97
3.3.6 Network > Route
Routing refers to selecting paths in a network along which to send data. Route configuration
page is shown in Figure 3.3.6.1.
Figure 3.3.6.1: Route configuration page
To configure Route:
a. To modify or remove specified route, click the button from “ Configure ” field.
b. If you want to add new route, click “ New Entry ” button. Routes – add page will display
as shown in Figure 3.3.6.2.
Figure 3.3.6.2: Routes – add page
Routes – add page contain the following parameter:

Subnet – Enter the IP address of destination subnet.

Netmask – Enter the IP address of destination subnet network mask.

Direct – Click on “Direct” drop down menu to select “Direct” or “Indirect”
route.

Device – Click on “Device” drop down menu to select device. For example,
WAN, VLAN0, VLAN1……

Comments – Enter the interface comments.

Active – Click on “Active” drop down menu to enable to disable this
interface.