9
Reset
This button is used to restore the all factory default settings.
Sometimes restarting the device will make the system back to
a normal state. However, if the system still got problems after
restart, user can restore the factory default settings and install it
again.
Restore the device:
1. While the Camera is ready and then press the button down
continuously.
2. Hold the button at least 5 seconds and release it. Then the
device has been restored to default settings and reboot again.
Note
Restoring the factory default setting will lose the all
previous settings included IP address forever. User
needs to run the IPWizard II program to search the
device and configure it to let the device work properly
again.
2.2.3 Installation
1. Fix IR camera to desired location with wall mount fixture.
2. Plug-in Ethernet Cable into RJ-45 connector.
Connect an Ethernet cable to the LAN socket located on the Network Camera’s
back panel and attach it to the network.
3. Connect RS485 D+ and D- (if you need to control PT scanner).
4. Connect the attached power adapters to camera and heater (option/by model)
and plug-in these adapters into power outlet.
5. Done.
