- 76 -
APPENDIX B - ACCESS CONTROL LIST APPLICATION GUIDE
Introduction:
What is Access Control List
An Access Control List (ACL) consists of a set of rules which are matched sequentially against a packet. When a
packet meets the match criteria of a rule, the specified rule action (Permit/Deny) is taken and the additional rules are
not checked for a match. On this sample the switch to which an ACL applies must be specified, as well as whether it
applies to inbound or outbound traffic. Rules for the ACL are specified/created using the ACL Rule Configuration
menu.
ACL Concepts
FGSW- ACL Configure screen
Object
Description
Group id
Input a group ID and
available range is 1-255
.
Action
To assign
“Permit”
or
“Deny”
for Access Control List
VLAN
To choose VLAN type as
“Any”
or by
“VID (1-4094)”
Packet Type
To choose Packet type as
“IPv4”
or by
“Non-IPv4”
IP Fragment
To decide to
“check”
or
“Uncheck”
the IP fragment
L4 Protocol
Provide additional L4 protocol for security on Layer 4 level
Current List
Display
“IPv4”
or
“Non-IPv4”
ACL groups, maximum up to 16 groups
Add button
Press this button for add Access Control List group on Web Smart Switch
Del button
Press this button for delete Access Control List group on Web Smart Switch
Summary of Contents for FGSW-2402VS
