T5
Instruction Manual
7
Binding microswitch
Binding LED
▼
3. The receiver status indicator will flash in groups of three.
Binding LED
flashing in threes
▼
4. Switch on the transmitter.
As the signals are acquired, the Binding LED will flash briefly and then glow solidly a few seconds later
indicating a successful binding.
▼
5. Operate your model as normal. The Binding LED glows solidly once bound with the transmitter.
TRANSMITTER USAGE
TRANSMITTER AERIAL POSITIONING
The transmitter aerial can be angled to optimise the transmitted signal. During operation keep the aerial pointing
upwards at all times. Do not fly with the aerial pointing downwards. Avoid pointing the aerial directly at your
model.
Keep the aerial pointing up–but not
directly at the model
RANGE AND POWER CHECK
▼
It is important to check the transmitter will operate the model satisfactorily at a safe range.
▼
In order to do this place your model on the ground and walk away from the model whilst operating the
swashplate/aileron controls. Have an assistant stand by the model and signal what the controls are doing
to confirm they operate correctly.
Check that the servos in the model operate without interference up to a distance of at least 100 metres.
▼
Ensure that fresh/charged batteries are being used for transmitter and receiver. Check that the transmitter
LED screen is displaying a voltage greater than 4.4V.
