26
GTEK170R
FAULT FINDING
FAULT FINDING TABLES
SYMPTOM
POSSIBLE CAUSE
SOLUTION
Although a fresh battery has been fitted,
the 170R will not switch on.
The battery has drained on the shelf.
Replace with another battery.
The battery connector is not making
proper contact with the battery.
Disconnect the battery. Gently squeeze the large terminal
on the battery connector to reduce its diameter.
Reconnect the battery.
Power cable is disconnected from the main circuit board.
Re-connect the power cable.
The power cable is damaged.
Repair or replace the power cable.
The battery does not seem to last
very long.
The battery type is of a low quality.
Use an alkaline or lithium battery.
Do not use a low quality or rechargeable battery.
When switched on, the 170R
displays SETUP or LOCKED.
The trigger is depressed.
Release the trigger or unscrew the trigger microswitch screw.
The 170R leaks from the solenoid
and/or manifold.
The two o-rings under the solenoid body or the gasket
under the solenoid plate are damaged or dirty.
Ensure the gasket is seated correctly.
Replace the gasket if damaged using 170R parts kit.
Check condition of the 5x1 NBR70 and 3x1 NBR70 o-rings
under the solenoid body.
Solenoid valve and/or manifold are over-pressurised.
Check the output pressure of the inline regulator,
adjust accordingly. Clean and inspect the inline regulator
assembly especially the piston o-ring, piston tip and regulator
seal. Replace damaged components as necessary.
Damaged or incorrect seals on the solenoid spool.
Replace and/or lubricate solenoid spool seals.
Damaged 170R SMC solenoid pilot valve.
Replace 170R SMC pilot solenoid valve.
The 170R leaks down the barrel.
Dirty or damaged can o-rings.
Clean and lubricate or replace 020 NBR70 and
017 NBR o-rings on the front of the can.
Dirty or damaged o-rings on the spool.
Clean and lubricate or replace the 011 NBR70 and
012 NBR70 o-rings on the main spool.
Dirty or damaged bolt o-rings.
Clean and lubricate or replace 14x2 NBR70 o-ring
on the back of the bolt.
Dirty or damaged rear bolt guide o-ring.
Clean and lubricate or replace 014 NBR70 o-ring
on the back of the bolt guide.
Summary of Contents for GTEK170R
