Planer Kryo 1060 Series, Operator'S Manual

Page: 32 / 43

ƒ ƒ ƒ ƒ Fan running, RUN lamp fails to light when RUN pressed
P Control board latched up.
Remedy : press reset button on rear of Controller or switch off
and then on.
P Blown mains input fuses in Controller.
Remedy : check/replace as required with identically rated
fuses.
P
Blown mains input or fuse on pcb in Controller.
Remedy : refer to Service Engineer.
ƒ
ƒ ƒ
ƒ
Fan running, RUN lamp on. No automatic cooling/heating
P If manual cooling or heating OK, then incorrect program
loaded, or controller latched up.
Remedy : press reset button on rear on Controller and/or run
correct program from DeltaT.
P If no manual cooling or heating - door interlock not operated.
Remedy : close door and push door handles down until they
latch.
P If no manual cooling and valve not clicking - faulty solenoid
valve.
Remedy : Position Solenoid Valve Selector to the other valve
for the next run and call Service Engineer.
P If no manual heating - thermal cutout has operated.
Remedy : refer to Service Engineer.
P If no manual cooling or heating - faulty door interlock switch.
Remedy : refer to Service Engineer.
ƒ
ƒ ƒ
ƒ
No manual cooling after pressing STOP (RUN lamp off), but
solenoid valve clicks.
P
No liquid-nitrogen supply due to Solenoid Valve Selector in
off position.
Remedy : Position to either valve A or B.
4-2 Troubleshooting