User’s Guide | 7
Connect the cables
The SD2220W unit comes with one 6-foot DVI cable, one 12-foot DVI cable,
and one 14-inch DVI cable.
1.
Plug one end of the 6-foot DVI cable
into the primary port of the dual-
channel DVI graphics card. Plug the
other end into the bottom monitor of
the SD2220W unit.
2.
Plug one end of the 14-inch DVI cable
into the secondary output of the
dual-channel graphics card. Plug the
other end into the input port (labeled
“IN”) of the mirror-flip PCI card.
3.
Plug one end of the 12-foot DVI
cable into the output port of the
mirror-flip PCI card (labeled “OUT”).
Plug the other end into the top monitor of
the SD2220W unit.
The two monitors must be connected with an off-the-shelf
video cable to comply with FCC regulations. Ferrite-core
interface cables are provided. This device will not be in
compliance with FCC regulations when a non-ferrite-core
video cable is used.
Short DVI cable installed
Summary of Contents for SD2220W
Page 1: ...SD2220W Stereoscopic Monitor USER S GUIDE www planar3d com...
Page 26: ......
