LT3200
Owner
Manual
12
|
P a g e
7- Once the LED connector, the two ground
connections, and the video connector have been
attached, position the rubber grommet into the
slot in the box as shown in Photo 7.
8- Position the lid over the lower half of the box
as shown, making sure the tab in the lid (arrow in
Photo 8) captures the grommet.
9- Refasten the four Phillips screws to secure the
Driver Box cover. The assembled Driver Box is
shown in Photo 9 at right.
Note: once the wiring bundle has been
connected, the protective release liner can be removed from the front surface of the display.
The power brick should be plugged into the driver box and a grounded power receptacle
during the removal.
Summary of Contents for LT3200
Page 1: ...LT3200 Owner Manual 1 P a g e Planar LT3200 Owner Manual ...
Page 8: ...LT3200 Owner Manual 8 P a g e IV Product Architecture LT3200 Block Diagram ...
Page 14: ...LT3200 Owner Manual 14 Page VIII Appendix Display Module Drawing ...
Page 15: ...LT3200 Owner Manual 15 Page Driver Box Drawing ...
