Planar LT3200, Owner'S Manual

Page: 10 / 19

LT3200 Owner Manual
10 | P a g e
VI. Connecting the Driver Box
The LT3200 is shipped with the wiring bundle disconnected from the Driver Box so the free
end of the bundle can be routed in the enclosure as part of the assembly process. This
section describes how to connect the wiring bundle to the Driver Box. You will need a small
(#1) Phillips screwdriver.
Note: It is important to follow the instructions carefully and observe safe ESD practices,
especially if the assembly is taking place away from a grounded workbench.
1- Remove the four Philips screws securing the
lid to the Driver Box and remove the lid. Locate
the LED ground wire loop at the free end of the
cable assembly (see Photo 1). The cable
assembly is attached to the display.
2- Remove the Phillips screw from the corner of the
video board closest to the cable slot. As shown in
Photo 2 place the screw in the ground wire loop
connector (upper arrow) from the cable bundle and
secure the screw back in place with the ground wire
loop (lower arrow).
3- Carefully position the free end of the LED wiring
bundle near the corner of the box that has the cable
slot. Locate the LED connector and orient it as seen
in Photo 3 at right. While avoiding placing any
stress on the attached wires, gently insert the
connector and fully seat it in the socket by pressing
on the edges of the connector, not the wires.