Plamen Tena N, Installation And Operating Instructions Manual

Page: 19 / 76

TENA N is a stove designed in accordance with current trends, featuring clean simple lines
that fit into any ambient style. The stove is made of high quality cast iron, painted with heat
resistant black paint giving a visually enhanced appearance to the product as a whole.
Large glazed door offers the view of the entire firebox and full experience of the open fire.
Thanks to a specific design of primary and secondary air supply, the glass remains clean
throughout the heating time. The stove design ensures long-lasting ember bed and the fire
needs not be extinguished for several days.
Please READ CAREFULLY THESE INSTRUCTIONS in order to achieve the best
performance at the very first use of the stove.
The stove meets all relevant EN 13 240 requirements and has marking affixed to it.
TECHNICAL DATA:
MEASUREMENTS: H x W x D 75x75x52 cm
WEIGHT:
161 kg
RATED OUTPUT: 7-11 kW
FLUE OUTLET: rear and top: Ø150 mm
HEIGHT OF THE OUTLET FROM
THE FLOOR TO THE CENTRE: 600 mm
SPACE HEATING CAPACITY:
up to 200 m
FUEL: wood, wood briquettes
INSTALLATION INSTRUCTIONS
The chimney connection on the supplied product is at the rear side. There is an option to connect
it to the top as well. To connect it to the top, follow the instructions shown in picture 4, page 75.
Install the front plinth (104) as shown on the figure on the cover page.
A spring may be installed on the lower hinge of the stove door to make sure that the door will not
remain open, except when firing or refuelling.
Figure 1
To install the spring, proceed as follows:
-Close the door, remove the front plinth, remove the pin from the lower hinge, insert the screw to
protrude some 15 mm from the hinge. Fix the spring onto the screw and pull it at one end to engage
the door edge. While holding the spring in the position, press the screw down and fix it with the nut
(see Figure 1).
3
19
Closed fronted local space heater