Installation
The pressure switch PSA10 can be mounted directly via the pressure connection or indirectly on a
hydraulic block using a hose or a minimess line.
The PSA10 must be fitted using a suitable open-end wrench (across flats 27) on the hexagon nut of
the pressure connection.
Do not install the PSA10 by gripping the housing, as this would damage the housing or the entire
instrument.
Electrical Connection
Attention:
Prior to the electrical connection of the device, it must be ensured that the supply voltage
matches that required and the supply voltage is switched off.
PIN assignment of M12x1 connector:
PSA10 Instruction manual 05/2018
page 4
