Pkm P 1-60 BBTX, Instruction Manual

Page: 14 / 23

14
Insert the grease filters and connect
the appliance to the mains
3 .
Check the correct position of the hood
from front and side perspective.
Otherwise the appliance will not
work properly.
Installation steps (recirculation mode)
If your home is not equipped with an air
outlet for extracting exhaust air to the
outside, the exhaust hose is not required.
The further installation is similar to the
INSTALLATION STEPS (EXTRAC-
TION MODE).
You can use carbon filters for odour ab-
sorption in recirculation mode only.
For installing carbon filters, remove the
grease filter. Press the lock and pull the
grease filter downwards.
Plug the carbon filter into the appliance
and turn in clockwise direction.
3 If the socket is covered by the chimney, you must plug in the appliance at an
earlier point in time.
15
1.
2.
3.
16
When the hood is connected with the power supply, there is one drops of
sound, the hood willbe in standing-by mood.
Power/Timer Button
Fan Speed Button
One touch on, is Low fan speed, is Medium fan speed, High fan speed.
Lighting On/Off
last use.
One touch on , and button will be lighted. The hood will be in mood of
Illumination key " ": In any state, touch the illumination key, the key will
light up, and the front light will turn on. When you touch this key again, the
key will go out and the light will turn off. (Illumination lamp is 2W,
independent control).
Illumination button " " :In any state, touch the illumination button, the
button lights, the rear illumination lamp is turned on, when touch this button
again, this The key goes out and the light turns off. (The illuminating lamp is
2W, independent control)
Timer/power button
When the hood’s speed on, one touch on power/timer button. The
hood comes to timer mode in 1 minutes. And two touch on power/timer
button, it swill stop the speed.