![background image](http://html1.mh-extra.com/html/pixsys/cnv510-pnet-rtu-a/cnv510-pnet-rtu-a_user-manual_1560851029.webp)
pag. 29
B3 command
This command allows to enable the Transparent: it will be possible to send Modbus commands directly from Ethernet side. The converter will become completely transparent.
Byte 0
Byte 1
0xB3
Enabling/disabling of
Transparent Mode
0x01 = Poll disabled
0x00 = Poll enabled
If the message is received correctly, the same message will be sent back by the converter.
Note:
When the Transparent Mode is enabled, the Modbus polling will stop on Modbus side.
Note:
The port used for send/receive the frames is defined in the section “Set Communication” step, in the field “Port”.
B4 command
This command allows to read the status of the Transparent Mode (enabled/disabled).
REQ:
Byte 0
0xB4
RES:
Byte 0
Byte 1
0xB4
Status
0x01 = Transparent Mode disabled
0x00 = Transparent Mode enabled
Summary of Contents for CNV510-PNET-RTU-A
Page 4: ...pag 4 MECHANICAL DIMENSIONS...
Page 5: ...pag 5 EXAMPLE OF CONNECTION...
Page 6: ...pag 6 CONNECTION SCHEME...
Page 7: ...pag 7 POWER SUPPLY...