5
Description
Possible Cause
Possible Solutions
Nothing Happens When Power is
Switched on.
Power shows 10%
Rotate Power-Dial in a Clockwise
Direction
Power adapter does not match
Please use power adapter that
comes supplied with the LED100B
MKIII Unit
Low Battery
Charge Battery Before Use
Circuit Board Damaged
Please Return to Vendor for Repair
Lack of Brightness
V-Lock battery cannot supply
enough power
Please use V-Lock battery Recom-
mended by PiXAPRO
Over-heat Protection has been
activated
Leave adequate cooling time be-
fore use
When turn on the light, the battery
displays inaccurate. Low battery
when increase brightness, full bat-
tery when decrease brightness.
Battery display test indicated usage
of time length in the current bright-
ness. Increase brightness requires
more battery; the usage time is
short, so battery display shows less
Normal
Items shown on LCD display are
incomplete, or the back-light is not
turning on.
LCD Display is malfunctioning
Please Return to Vendor for Repair
How To Use
Troubleshooting
confirm and save your settings. You can also leave your adjustments for about 2 seconds to automatically save.
The LED100B MKIII can be set to a total of 100 Light numbers.
5. Overheat Protection
The LED100B MKIII features a built-in temperature controller and an ultra-quiet cooling fan (<18dB), strictly to
regulate the temperature of the LED100B MKIII body. Since the LED100B MKIII uses the rear-conduction heat
dissipation method, the heat from the LED chip is channelled directly to the LED100B MKIII’s housing where the
heat is dissipated.
If the temperature of the shooting environment is too high, the LED100B MKIII’s body temperature will increase. If
it rises above about 58°C, the output power will be automatically reduced by 50% to protect the LED chip from
overheating and sustaining permanent damage. If the temperature of the LED100B MKIII continues to increase,
the LED chip will automatically switch-off until the unit cools back down to a safe working temperature. After
restarting, the LED100B MKIII everything should go back to normal.
Optional Accessories
Optional accessories for the PiXAPRO LED100B MKIII include:
2.4GHx Wireless Remote control, 2.4GHz Wireless remote control receiver dongle, V-Lock battery plate,
S-Type fitting softboxes, reflectors, barn door sets etc. (Sold Separately).
