3
POWER
Ready Mode
Turn the power switch
to Ready mode.
3.Affix the
Cushion Tape
to the base of the meter, connect the Gauge Cable to the
Meter, and install the Meter into the Meter Holder.
Please add the Cushion Tape
if the Meter not fixed.
1. F a s t e n u s i n g t h e
double-sided tape.
N ote : Please be sure ab out
where you wish to install the
meter, as it is not advisable to
reuse double-sided tape.
Meter Holder
Gauge
Cable
Back side
of Meter
Clean
to remove
oil and dust
Double-sided
tape
2.After deciding the position
and angle of the meter face,
fasten the Hexagonal bolt
on both sides to secure.
Connector
Cushion Tape
Cushion Tape
Cushion Tape
Hexagonal bolt
A Installation with the Meter Holder
Installing The Product
Installing The Meter
1
4
5
2
3
Basic Operation
Display Each Mode
Meter OFF
Opening Demo
Engine Stop
The needle stops
in the vicinity of
lowest value.
Gauge
Cable
Cut the Cushion Tape in half, affix to base of the Meter to be on press
fit condition with adjusting number. And connect the Gauge Cable to
the Meter and insert into the panel.
Cushion Tape
Cushion Tape
B Installation to panel or something
C Installation to A-pillar using A-pillar Stand
Panel
Cut the Cushion
Tape in half
Make a ø5 hole on the place to install the meter of the A-pillar, and fix the
Meter using A-pillar Stand with Screw and Nut.
A-pillar
Screw
Nut
A-pillar
Stand
ø5 Hole
A-pillar
Unit
Zip tie
(Large)
Through
holes
Thick cable
or pipe
When Fastenings to
a Cable or Pipe
(Example of Installation)
Double-sided
tape
Clean to
remove
oil and dust.
Fastening
to Flat Space
On the back side
of the under cover
Under the steering
column cover
Do not install into low positions
Installing The Unit
As shown in the below diagram , fasten the unit into
positions not usually affected by water.
On the inside of
the driver’s door
• When in Ready Mode the needle will move to the extreme left several
times for searching position. Then it will move to the maximum value
and finally to reading for current measurement item.
Opening
Demo
• Due to analyzation time for the car data transmission it may take up to a few
seconds from engine start before opening demo. (except wiring IGN)
