9
MET-1
50480:A
04/11/97
The following steps must be completed to connect the factory-installed battery:
NOTE
The battery may require charging prior to use.
Remove two screws from the top and two screws from the bottom of the MET-1 enclosure
(refer to
Figure 2.5-1
).
Remove the MET-1 enclosure, in doing so, be careful to pull the enclosure over the power switch
and the SELECT and START push-buttons.
Plug the keyed battery connector into the header with the keyed side up (refer to
Figure 2.5-2
).
Position the MET-1 enclosure over the power switch and the SELECT and START push-buttons.
Replace the two top screws and the two bottom screws of the MET-1 enclosure.
Figure 2.5-2 Bottom Inside View of the MET-1
Figure 2.5-1 Top and Bottom View of the MET-1
www.PDF-Zoo.com
