1.1 important power information
Read Instructions:
Please read the Lifeforms Percussion Sequencer manual completely before use
and retain for future reference.
IMPORTANT Ribbon Cable Power Information:
The Lifeforms Percussion Sequencer is a eurorack format synthesizer module.
The module can be installed, rearranged, removed, and replaced in any
compatible eurorack enclosure from Pittsburgh Modular or other manufacturers.
The Lifeforms Percussion Sequencer uses a standard 10 to 16 pin eurorack
ribbon cable to connect the module to a b/-12v power supply. Please
pay very close attention to the orientation of the ribbon cable when adding and
removing modules. The stripe on the ribbon cable marks -12v. This stripe needs
to line up with the -12v pins on the power rail and the -12v pins on the module.
The Lifeforms Percussion Sequencer includes reverse polarity protection so it
will not be damaged when plugged in incorrectly; however, as a general rule,
failure to match up the pins correctly can result in damage to one or all the
modules in a case. On a Pittsburgh Modular enclosure power rail, the -12v pins
are clearly labeled. On the Lifeforms Percussion Sequencer module, the positive
side of the pin connector is on top, and the negative sides of the pin connector
is on the bottom so the red stripe should be toward the bottom of the module.
Do NOT remove the Lifeforms Percussion Sequencer module from any
case while it is plugged in.
Do NOT unplug ribbon cables from the Lifeforms Percussion Sequencer or
case while the case is plugged in.
1. important information
3
