Page 3
For technical questions, please call 1-888-866-5797.
Item 63609
Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use of this product.
Note:
For additional information regarding the parts listed in the following pages,
refer to
Parts List and Diagram
on page 6.
Assembly
1. Slide Handle Crossbar (2) through hole
in the handle-end of Slide Screw (3).
2. Place Slide Hammer (12)
onto the Slide Screw.
NOTE:
This tool will exert strong forces
on the object being pulled and may
damage some objects during removal,
depending on the force required.
Two-Jaw Pulling
1. Decide if you need the Small Jaws (9),
Large Jaws (10), or the Two-Jaw
Puller Adapter (8). The Adapter
is smaller and should be used for
narrower, hard-to-reach objects.
2. Determine if you need to attach the
Jaws for an internal or external pull.
• An external pull allows the jaws to
grip the outside surface of the object.
• An internal pull allows the jaws to
grip the inside surface of the object.
3. Assemble the Small Jaws or Large
Jaws to the Jaw Adapter using the
two Locking Pins (1). If you are
using the Two-Jaw Puller Adapter,
attach it directly to the threaded
end of the Slide Screw (3).
4. Thread the assembled Jaws/Jaw
Adapter onto end of Slide Screw.
5. Attach the Jaws to the
object to be pulled.
6. Push the Slide Hammer toward the
object to be pulled. Forcefully pull the
Slide Hammer toward the handle end.
7. Repeat Step Six until the object
is successfully pulled.
Brought to You by www.snapwhole.com
Brought to You by www.snapwhole.com
