39
38
DOC_NIP_CON_SMART_EN_20200619
DOC_NIP_CON_SMART_EN_20200619
EN
EN
If necessary, clean the sensors (PET/stainless steel) and protective cover (TPU/PC) of
the tablet with a soft cloth and common, not too aggressive cleaning agents.
Dirt on the hand-held device can be removed with a dry, lint-free cloth.
If the tablet is still contaminated despite the protective cover, please note the
manufacturer's instructions
(
Tablet: Safety Information)
.
9
Storage, Transportation
The practical device case included in the scope of delivery ensures that the device
can be transported safely.
Always store the measuring system in a dry place. Avoid strong impacts and vibra-
tions on the device. The general safety instructions for the transport and storage of
batteries apply.
The hand-held device can be secured against unintentional start-up
during transport using the slide switch (9)
(
Section 6.2 Operation
and Control Elements)
(IATA VA967 Teil II).
10 Repair
Repairs and service measures to the measuring system may only be
carried out by the manufacturer.
To avoid unnecessary questions, send the device with a short
description of the error to:
PITSID Polygraphische innovative Technik Leipzig GmbH
Mommsenstraße 2
D-04329 Leipzig
Tel:
+49 341 25942-0
Fax:
+49 341 25942-99
E-Mail: [email protected]
Web: www.pitsidleipzig.com
If the replacement of parts (e.g. sensors) becomes necessary after a longer period of
use, contact the above address
11 Disposal
PITSID Polygraphische innovative Technik Leipzig GmbH takes over the disposal of
sent in old devices of the NIP CON SMART Measuring System.
In the case of independent disposal, the current safety regulations for the
disposal of lithium-ion polymer batteries must also be observed.
The NIP CON SMART Measuring System must be disposed of as
electronic waste in accordance with the applicable laws. PITSID
Polygraphische innovative Technik Leipzig GmbH is registered in the
WEEE directive (Waste Electrical and Electronic Equipment) register
under WEEE reg. No. DE73410149.
Attachment
CE Declaration of Conformity
The PITSID – Polygraphische
Innovative Technik Leipzig GmbH
Mommsenstraße 2
D-04329 Leipzig
as manufacturer and distributor for the product declares:
Name:
Contact Zone Measuring System NIP CON SMART
Series: 36-0010.0/0
As of device number: KSM-00400
on the basis of
▬
EMC Directive 2014/30/EU of the European Parliament and of the Council of
February 26, 2014 on the harmonization of the laws of the member states
relating to electromagnetic compatibility
▬
Radio Equipment Directive (RED) 2014/53/EU of the European Parliament and of
the Council of April 16, 2014 on the harmonization of the laws of the member
states regarding the provision of radio equipment on the market and to repeal
Directive 1999/5/EC
▬
RoHS Directive 2011/65/EU of the European Parliament and of the Council of June
8, 2011 on the restriction of the use of certain hazardous substances in electrical
and electronic equipment
that the product described above corresponds in its design and construction as well
as in the version placed on the market to the provisions of the EU directives menti-
oned. If the product is changed without knowledge from the manufacturer, this
declaration becomes invalid.