Fluid Power Car User Guide 60070 V0113
3
Materials Included
• Bag of laser-cut parts
• CD Hub & Bearing Set (only hubs and screws will be used)
• 2 metal one-way bearings
• 4 – 1/4" x 1/2" nylon spacers
• 4 – 3/8" x 5/8" nylon spacers
• 4 – 1" screws
• 2 – 3/8" screws
• 1" wooden dowel
• 4 nylon axle bushings
• 2 axles
• 2 wide rubber bands
• 12 cc syringe
• 6 cc syringe
• Flexible tubing
• Piece of thread
Items Required (not included)
• Small Phillips screwdriver
• Sturdy scissors or wire cutters
• White glue (such as HD Bond II) or CA glue
• File or emery sandpaper/cloth
• Small pliers (optional)
• Cup of water
Building the Car
1. Open the bag of laser-cut parts. Pop
out any interior pieces that need
removed.
2. Using wire cutters trim off two edges
of the 6 cc syringe plunger as shown.
3. Place the syringe plunger into the
slots of the Part 4 with the two circles
on it (they should face away from
the plunger). Make sure the trimmed
edges of the plunger are facing up
and down, not side to side.
Step 2
