Operating
Instructions for
Electrical Heater Units
PITSAN
Page 3 / 16
PİTSAN MAK. SAN. VE TİC. LTD ŞTİ,
Esenyurt Yolu Üzeri No: 66 - 68 Bağlar Mevkii, TR – 34850 Avcılar - İSTANBUL
Tel.: 0212/4281885, Fax: 0212/4281661, Email:
,
http: //www.pitsan.com
1
GENERAL
Always read the Safety Instructions chapter of these operating instructions before putting the
heater into operation.
Even loss of life and loss of property can result from nonobserving the following instructions or
the valid national and international safety regulations.
Installation, electrical connection, commissioning and maintenance are only to be carried out
by authorised personnel and in accordance with requirements and current legislation. There
should be enough space provided for a safe working on service and maintenance.
2 SAFETY
2.1 Safety instructions
Caution:
To avoid possible electrical shock, ensure the power is turned off before attempting
to wire. All wiring must be in accordance with local electrical codes. This equipment requires a
ground as precaution against electrical shock.
Basic precautions should always be followed to reduce the risk of fire, electric shock, and
injury to persons.
- Disconnect all power supplies before working on circuit.
- Do not heat air containing combustible materials.
- Mount heater out of reach.
- Install at least 2ft. (61 cm) from fl oor except 40 - 60 kW at least 8 ft. (2.4 m) from fl oor.
- Do not use outdoors.
- Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may
cause an electric shock or fire, or damage the heater.
- Do not block air intakes or exhaust in any manner.
- Heater contains arcing and sparking parts. Do not use it in areas where gasoline, paint, or fl
ammable liquids are used or stored.
- Use this heater only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock, or injury to persons.
- Connect only to the voltage and frequency specified on the nameplate.
- Wire used to connect to the heater should have insulation rated to at least 75
°C.
- Connections are to be made as shown on the wiring diagram
