SV62750 Rev. A | Operator Guide
6 | SH59 Shredder
4
5
6
1
2
3
Item
Icon
Meaning
Description
1
Operation
Error
Lights when one of the following occurs:
•
Material jam in machine
(too much material has been fed into the
cutters) - the cutters jam, run in reverse for a short time, and stop. The
motor turns off.
•
Simultaneous material feed
(material has been fed into both slots
at the same time) - the cutter mechanism stops, runs in reverse for a
short time, and stops. The motor turns off.
•
Material sensors blocked when door open
(there is material left
in one of the two feed slots when the door is opened) - the cutter
mechanism stops and the motor turns off.
•
Material sensors blocked when machine turned on
(there is
material left in one of the two feed slots when the machine is switched
on) - the cutter mechanism does not start.
2
Lubrication
Needed
Lights when the cutter mechanism needs lubricating. See Maintenance
section for procedure.
3
Door Open/
Fault
Lights when one of the following occurs:
•
Door open
(the door for the paper collection bin is open) - the
machine turns off and cannot be started as long as the door remains
open.
•
Electrical fault
(there is an electrical fault in the door sensor) - the
light flashes and the machine turns off. Call for servicing.
4
Motor/
Electrical
Fault
Lights when one of the following occurs:
•
Motor protection
(motor has been overloaded) - the machine turns off
and cannot be started until the motor has cooled down.
•
Electrical fault
(an electrical fault occurred inside the control board) -
the light flashes and the machine turns off. Call for servicing.
5
CD/DVD
Collection
Tray Full
Lights when the CD/DVD collection tray is full and needs emptying. The
machine stops. (You can still feed paper in the paper slot during this time.)
6
Paper
Collection
Bin Full
Lights when the paper collection bin is full and needs emptying. The
machine stops. (You can still feed CDs/DVDs in the CD/DVD slot during
this time.)
Control Panel Icons
