SDC2035C Communication Device Advanced Setup Guide
Setting up a wired network connection
EN
<< Return to Contents
LAN connection (Router,
Hub, Wall socket)
Network Cable
Communication
Device
Introduction
Your Communication Device is supplied configured to connect as a plug-and-play
device if your network meets the following criteria:
• uses DHCP
• is open to HTTP and HTTPS traffic
• does NOT use a proxy server
If your network meets these criteria, just
follow the printed instructions supplied in
the DM50/DM55/DM60 series Installation Guide supplied with your machine
.
This section is needed only if your network requires special settings to operate
properly, such as static IPs and proxy server settings. These settings will need
to be added to the Communication Device. You may need the help of your IT
specialist/network administrator to do this.
Follow the instructions exactly in the sequence that follows.
• If you are installing your Franking Machine and have just taken the
Communication Device out of its box, it will be in the factory default state
and you can continue with the steps that follow. If the Communication Device
has been configured and used before, first reset it as described
here
before
proceeding.
1. Connect the Communication Device
a. Connect the Communication Device to your network as shown.
b. Plug the AC power adapter into
the Communication Device and
a power outlet. The left LED is lit
yellow when it is on.
c. After a short time, check that the
right LED is blinking orange and/
or green.
LEDs
LEDs
AC Power Adapter
