INSTALLATION & START-UP
Location
For proper operation and maximum performance, locate the Crisp n’
Hold in an ambient air temperature of 70º F (21ºC).
Avoid areas near exhaust fans where there is active air movement.
For safe operation, locate the unit a reasonable distance from com-
bustible walls and materials.
To prevent injury and damage, locate the unit at a proper and safe
working height. The location should be level, clean of debris, and
strong enough to support the weight of a fully loaded unit.
Countertop Mounting
To prevent electrical shock, be sure unit is unplugged from an elec-
trical outlet. If unit has been operated, allow unit to cool before in-
stalling.
Counter must be made of a non-combustible material, clean and
free of debris. Locate and drill four mounting holes in counter top.
Remove legs from unit and secure to counter top using threaded
mounting holes previously occupied by legs. Seal the perimeter of
unit where it meets the counter top with a silicone sealant.
GROUNDING INSTRUCTIONS
This appliance is equipped with a cord having a grounding
wire with a grounding plug (except export units-ship w/o plug)
which must be plugged into an outlet that is properly installed
and grounded. In the event of an electrical short circuit,
grounding reduces the risk of electric shock by providing an
escape wire for the electric current.
WARNING—Improper use of the grounding can result in
a risk of electric shock.
Consult a qualified electrician or
serviceman if the grounding instructions are not completely
understood, or if doubt exists as to whether the appliance is
properly grounded.
Start-up
1. Plug the Crisp n’ Hold into a properly grounded electrical recep-
tacle.
2. Ensure all plastic and packaging materials have been removed.
3. Set POWER switch to “ON” position.
4. Do not load product into the cabinet. Allow the heat to remove
any residual oils which may adhere to inside metal surfaces. A
slight emission of smoke is normal for the first few hours of
operation.
5. Appliance is preset at the factory, no temperature adjustment is
necessary.
5
WARNING:
Risk of personal injury
Installation procedures must be
performed by a qualified technician
with full knowledge of all applicable
electrical codes.
Failure can result in personal injury
and property damage.
IMPORTANT:
Power cord is 7' long
(2.13m)
If necessary, contact a licensed
electrician to install an appropriate 20
amp electrical circuit with correct
NEMA receptacle.
CAUTION:
Electrical Shock Hazard
The ground prong of the power cord is
part of a system designed to protect
you from electric shock in the event of
internal damage.
DO NOT cut off the large round ground
prong or twist a blade to fit an existing
receptacle.
IMPORTANT:
Not under warranty:
Damage to unit due to being
connected to the wrong voltage or
phase is
NOT
covered by warranty.
CAUTION:
Risk of personal injury
Unit is not waterproof, to avoid
electrical shock keep unit and counter
from being submerged in water. Do
not operate if unit has been
submerged in water.