ENGLISH
7
ASSEMBLY INSTRUCTIONS
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed.
1. MAIN BARREL SET-UP FOR ASSEMBLY
Parts Required:
1 x Main Barrel /Hopper Assembly (#11)
Installation:
• Place a piece of cardboard on the floor to prevent scratching the unit
and parts during assembly. Remove all the component parts from the
main barrel and set aside.
• Lay the Main Barrel on its side on the foam, hopper end pointed upward.
The opening in the foam for the spout hook, which allows the Main
Barrel to sit level on the foam.
ASSEMBLY PREPARATION
Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister pack
after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill before
assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt to
assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss® Customer Service for parts: Monday
through Sunday, 4am - 8pm PST (EN/FR/ES).
[email protected] | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
IMPORTANT: To ease installation, using two people is helpful (but not necessary) when assembling this unit.
Tools required for assembly:
screwdriver and level.
Tools not included.
1
11
