19
MANUAL LIGHTING PROCEDURE
1. Open lid during lighting.
2. Set all Control Knobs to the “Off” position.
3. Open the cylinder/gas valve according to the operating
instructions on tank.
4. Quickly and carefully, using a long match or long-nosed
lighter, place a lit flame near the burner and watch the burner
catch flame. Gain access to the burner from beneath the
Cooking Grids and Heat Tents. Position lit match near the side
of the burner.
CAUTION: Do not attempt to light another area of the
burner. This can cause injury.
5. If the burner does not light within 5 seconds, turn burner
Control Knob to “Off”, wait 5 minutes, and repeat lighting
instruction. After lighting, observe the burner flame. Make
sure all burner ports are lit and flame height matches
illustration shown previously.
NOTE: Each burner lights independently - repeat same steps for other burner.
WARNING: Never lean over the cooking area while lighting your gas grill. Keep your face and body a safe
distance (at least 457 mm / 18 inches) from the cooking grid surface when lighting your grill by match.
6. If the above points do not work, see
Troubleshooting.
SHUTTING OFF YOUR GRILL
1. When finished cooking, turn gas cylinder valve to the CLOSED position, and allow the regulator knob to pop out. This safety
feature locks the regulator knob to ensure that the gas is no longer flowing.
2. Turn Control Knobs to the “Off” position.
NOTE: A “poof” sound is normal as the last of the LP gas is burned.
3. Disconnect gas supply by following the
Disconnecting A Gas Cylinder
instructions.
WARNING: Allow the grill to cool completely, and remove the gas cylinder, before moving, travel, or for
storage.
Summary of Contents for Mile Hybrid
Page 41: ......
