8
the wheel, then the leg hole, wheel washer, and finally secure using the
wheel cotter pin. Note illustration for order. Repeat installation for the
other wheel. Once installed, from the rear of the grill, lift the grill into
an upright position.
3. SECURING THE LID STOPPER
Parts Required:
1 x Lid Stopper
(#4)
Installation:
• Secure the lid stopper onto the top of the main barrel using the
pre-installed screw on the top of the main barrel.
4. INSTALLING THE HOPPER TO THE BARREL
Parts Required:
1 x Hopper Assembly, Drop Chute Plate and Screw
(#9)
1 x Probe Wire Casing
(#6)
4 x Screw
(#A)
4 x Locking Washer
(#B)
4 x Washer
(#C)
1 x Power Cord Bracket
(#5)
Installation:
• Secure the drop chute screw to the drop chute plate, and insert into
the horizontal slit on the rear side of the hopper.
• Align the burn pot end of the hopper assembly into the opening on
the end of the main barrel. Insert only half-way, then carefully slide the
hopper assembly completely into the opening on the end of the main
barrel. Secure the hopper assembly to the main barrel, from the inside
of the barrel, using four screws, locking washers, and washers. Take care
not to over-tighten to avoid stripping the screws. Note illustration 4A.
• On the rear side of the hopper, connect the silver grill probe
temperature wires – extruding from the main barrel – to the wire
connections from the rear of the hopper assembly. Remove the
two pre-mounted screws. Tuck the excess wire into the probe wire
casing, placing the wire distinctly in the divet along the edge to avoid
pinching. Next, secure the probe wire casing to the hopper using the
two screws previously removed. Note illustration 4B.
IMPORTANT: Ensure the grill probe temperature wires do not get
pinched. Damage to the grill probe temperatures wires may result in
incorrect readings, or inability to funtion.
• Secure the power cord bracket using the two screws pre-installed on the
rear side of the hopper, above the drop chute plate. Note illustration 4C.
5. ASSEMBLING THE LID HANDLE
Parts Required:
1 x Lid Handle
(#11)
2 x Lid Handle Bezel
(#10)
5A
4C
3
4B
4A
REAR VIEW
A
C B