Page
10
of
15
7. For best results, mop using a steady back-and-
forth motion over the floor,
working your way backwards in order to avoid walking over the freshly
mopped area.
IMPORTANT
: To avoid warping or damage caused by heat and moisture,
do not use on unsealed hardwood or unglazed ceramic surfaces. Steam
may remove the sheen from some floors that have been treated with wax.
Never allow your
Steam Mop to rest idle on floor surfaces while still
On –
prolonged exposure to steam in a single area may discolour or damage
some floors. If it becomes necessary to stop mopping at any time, always
turn the unit off and place back on the Resting Pad.
8. Once all the water has been used, the Green Heating Indicator Light will
turn off to show that the Water Tank / Boiler is empty. If you wish to
continue mopping, first turn off by pressing down gently on the On/Off
Switch until it clicks, then unplug the power cord from the power outlet.
Refer to “Refilling” procedure before attempting to refill the Water Tank /
Boiler. Do Not refill whilst the unit is hot.
9.
The Microfiber Pad will absorb dirt and moisture during mopping.
However, when you are finished you may find some residual moisture has
been left behind. In this case, it is recommended to allow the floor time to
air-dry. A fan may be directed towards the mopped area to facilitate
drying.
10. Once your mopping tasks are completed, place the unit back on the
Resting Pad and turn it off by pressing down gently on On/Off Switch until
it clicked. Unplug the power cord from the power outlet, then refer to the
“Storage” procedure for proper storage and care of your Steam Mop.
CAUTION
: Take care when around the Steam Mop as the steam and
surfaces are very hot and may cause injury.
DO NOT
direct the steam towards persons, animals or other electrical
products.
