INSTALLATION
ELECTRICAL CONNECTION
WARNING!!!!
DO NOT USE EXTENSION CORDS (VOIDS WARRANTY)
Ground:
The electrical outlet must be provided with an efficient ground, and the voltage and the
frequency of the electrical line matches those indicated on the data plate.
If unsure about the efficiency of the ground, have your electrical circuit
checked by a qualified electrician
• Carefully remove unit from carton or crate. Remove all loose packing materials,
making sure that no small parts or accessories are lost. Inspect the unit for concealed
damage before discarding packing materials.
• It is the responsibility of the installer to comply with all local codes.
• Check unit nameplate for electrical requirements. Make sure that the control knob is
set to the “OFF” position. Connect the electrical power cord and plug to a properly
sized power source of the correct voltage. See wiring diagram on page 12.
• Turn the control knob to the number 5 setting; pilot light will glow and the bottom of
the well will start to warm. As soon as you notice heat turn the thermostat “OFF”.
CAUTION: Bottom of
well will heat rapidly and
may cause severe burns
if touched. Well will turn
a blue-black color due to the high
heat produced when operated dry.
This is normal and will not harm the
well.
4
8”
6-1/2”
A
B
4-1/2”
2-3/4”
CUTOUT DIMENSIONS
