35
YPM-2306ZF
When the above conditions are all met and the focus is
closed, the XSI pin goes to low from the current high,
then 40 ms later, the microcomputer begins to monitor
the RFOK signal after it that has been passed through
the low pass filter.
When the RFOK signal is recognized as low, the micro
computer carries out various actions including protec-
tion.
Fig.11 a series of operations carried out relevant to the
focus close (the figure shows the case where focus
close is not available).
You can check the S-curve, search voltage and actual
lens behavior by selecting the Display 01 for the focus
mode select in the test mode, and then pressing the
focus close button.
REFO
FD
LENS POSITION
RELATIVE TO DISC
NEAR
FAR
"JUST FOCUSED"
MD
REFO
Expanding around "Just Focused Point"
REFO
RFI
FOK
FE
FZD
THRESHOLD
LEVEL
FZD
(INTERNAL SIGNAL)
Focus closing would normally take place at these points
XSI
(IN THE EVENT
FOCUS IS
CLOSED)
LEVEL
Fig.11 : FOCUS CLOSE SEQUENCE
Summary of Contents for YPM-2106ZF
Page 3: ...YPM 2306ZF 2 EXPLODED VIEWS AND PARTS LIST 2 1 CD MECHANISM MODULE 3 ...
Page 11: ...11 YPM 2306ZF ...
Page 13: ...13 YPM 2306ZF 1 2 3 4 1 2 3 4 D C B A SIDE B A CLAMP CONTROL UNIT S8 A ...
Page 19: ...19 YPM 2306ZF Grating waveform Ech Xch 20mV div AC Fch Ych 20mV div AC 45 0 75 60 30 90 ...
