Pioneer VSX-C301-S, Service Manual

Page: 102 / 103

VSX-C301-S
102
1 2 3 4
1 2 3 4
C
D
F
A
B
E
SOUND MODE
Use to select a SOUND MODE for the current
source.
DIALOG
Press to switch on/off DIALOG (dialog
enhancement).
10 MUTE
Press to mute all output. Press again (or adjust the
volume using the
MASTER VOLUME control) to restore
the sound.
11 SIGNAL SELECT
Use to select the analog or digital signal for the DVD ,
TV/SAT , DVR/VCR and FRONT inputs.
12 MASTER VOLUME
Use to adjust the volume.
13 ROOM SETUP
Use to select a preset room setup.
14 SYSTEM SETUP
Press to access the SYSTEM SETUP menu to make
detailed receiver settings.
15 Cursor keys and ENTER
Use to navigate menus and select options/execute
commands.
16 VIRTUAL SB
Press to switch on/off the virtual surround back mode.
17 DIMMER
First press RECEIVER , then press DIMMER repeatedly to
change the brightness/switch off the front panel display.
The display will light brightly for about two seconds when
you operate the receiver with the display off or dimmed.
(Note that the master volume indicator always remains
lit, even when the rest of the display is off.)
18 Playback controls
Playback controls for external components, such as DVD
and CD players.
Functions printed in blue control the built-in tuner; other
functions control other external equipment.
19 Number buttons
Use for numerical input of track numbers, radio
frequencies, and so on.
20 CHANNEL +/–
Use to change channels on a satellite receiver, cable
box, VCR or DVR.
21 TV CONTROL buttons
Use to control your TV (after setting up the remote
control to work with your TV).
The default preset codes are shown in the table.
Input/control mode
select button Preset
code Component
(manufacturer)
DVD 020 DVD (Pioneer)
TV/SAT 200 STB (Pioneer)
DVR/VCR 466 DVD recorder
(Pioneer)
FRONT 100 LD (Pioneer)
FM/AM n/a (built-in tuner)
TV CONTROL 600 TV (Pioneer)
Clearing preset codes
This restores all presets to the factory defaults. See
Using the remote control with other components
for the default remote settings.
• Press RECEIVER and number button ‘0’ (zero) at
the same time. Keep them pressed for about 3
seconds.
The LED on the remote control blinks three times
indicating all the preset codes have been cleared.