Additional information
10
51
En
English
Français
Deutsch
Nederlands
Italiano
Español
Resetting the main unit
Use this procedure to reset all the receiver’s
settings to the factory default. Use the front
panel controls to do this.
VSX-415 model:
1
Switch the receiver into standby.
2
While holding down the TONE button,
press and hold the
STANDBY/ON button for
about three seconds.
3
When you see RESET? appear in the
display, press the TONE button.
OK?
shows in the display.
4
Press TONE once more to confirm.
OK
appears in the display to indicate that the
receiver has been reset to the factory default
settings.
VSX-515 model:
1
Switch the receiver into standby.
2
While holding down the TONE button,
press and hold the
STANDBY/ON button for
about three seconds.
3
When you see RESET? appear in the
display, press the
ENTER
button.
OK?
shows in the display.
4
Press
SYSTEM SETUP
to confirm.
OK
appears in the display to indicate that the
receiver has been reset to the factory default
settings.
Switching the speaker
impedance
We recommend using speakers of 8
Ω
with this
system, but it is possible to switch the imped-
ance setting if you plan to use speakers with a
6
Ω
impedance rating.
•
With the receiver in standby, press
STANDBY/ON
while holding down the
SPEAKER IMPEDANCE
button.
Each time you do this, you switch between the
impedance settings:
•
SP 6 OHM
– Use this setting if your
speakers are rated at 6
Ω
.
•
SP 8 OHM
– Use this setting if your
speakers are rated at 8
Ω
or more.
When a search is performed
by a DTS compatible CD
player during playback, noise
is output.
• This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
Can’t operate the remote
control.
• Replace the batteries (refer to page 5).
• Operate within 23 ft. (7 m), 30° of the remote sensor on the front
panel (refer to page 5).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
The display is dark or off.
• Press
FL DIMMER
on the remote control repeatedly to return to
the default.
Problem
Remedy
VSX_415-515.fm 51 ページ ２００４年１２月８日 水曜日 午後３時１２分
