The System Setup menu
07
45
En
English
Français
Deutsch
Nederlands
Italiano
Español
The Other setup menu
The Other menu is where you can make
customized settings to reflect how you are
using the receiver.
1
Select OTHER from the System Setup
menu.
See
Making receiver settings from the System
Setup menu
on page 41 for more on this.
2
Use
/
(cursor left/right) to select the
setting you want to adjust then press
ENTER
.
If you are doing this for the first time, you may
want to adjust these settings in order:
•
DRC
– Specify the amount of dynamic
range adjustment to Dolby Digital
soundtracks (see
Dynamic Range Control
Setup
below).
•
DUALMONO
– Isolate one channel when
listening to discs with dual mono encoding
(see
Dual Mono Setup
below).
•
LFE ATT
– Set the attenuator level for the
LFE channel (
LFE Attenuator Setup
below).
3
Make the adjustments necessary for each
setting, pressing RETURN to confirm after
each screen.
Dynamic Range Control Setup
• Default setting:
OFF
This setting specifies the amount of dynamic
range adjustment to Dolby Digital and DTS
movie soundtracks. You may want to use this
when listening to surround sound at low
volumes.
1
Select DRC from the OTHER setup menu.
2
Use
/
(cursor up/down) to choose the
setting that you want.
•
OFF
– No dynamic range adjustment (use
when listening at higher volume).
•
MID
– Mid setting.
•
MAX
– Dynamic range is reduced (loud
sounds are reduced in volume while
quieter sounds are increased).
3
When you're finished, press
RETURN
.
Dual Mono Setup
•
Default setting:
CH1
You can specify how dual mono encoded Dolby
Digital soundtracks should be played. Dual
mono is not widely used, but is sometimes
necessary when two languages need to be sent
to separate channels.
1
1
Select DUAL MONO from the OTHER
setup menu.
2
Use
/
(cursor up/down) to choose the
setting that you want.
•
CH1
– Only channel 1 is played
•
CH2
– Only channel 2 is played
•
CH1 CH2
– Both channels are played
through the front speakers
3
When you're finished, press
RETURN
.
LFE Attenuator Setup
• Default setting:
ATT 0 dB
Some Dolby Digital and DTS audio sources
include ultra-low bass tones. Set the LFE
attenuator as necessary to prevent the ultra-
low bass tones from distorting the sound from
the speakers.
1
Select LFE ATT from the OTHER setup
menu.
2
Use
/
(cursor up/down) to choose the
setting that you want.
•
LFEAT 0
– No limiting (recommended
setting)
•
LFEAT 10
– 10dB of limiting
•
LFEAT **
– No sound from LFE channel
3
When you're finished, press
RETURN
.
Note
1 This setting works only with dual mono encoded Dolby Digital and DTS soundtracks.
VSX_415-515.fm 45 ページ ２００４年１２月８日 水曜日 午後３時１２分
