35
SET
UP
Initial Setup
Initial Setup
4 Adjust speaker levels so that you hear the
test tone at the same volume from each
speaker when seated in your main listening
position.
Note: The volume of the subwoofer tends to sound lower than
it actually is, you may need to raise its level after testing the
sound with actual soundtracks.
In AUTO mode
The receiver will automatically cycle through the speakers
emitting a test tone from each one. It will continue to do this
until you press ENTER to signify you have finished your adjust-
ments.
In MANUAL mode
1
Press
ENTER
2
Press the
5
/
∞
buttons (or the MULTI JOG dial) to adjust the
level of the speaker outputting the TEST TONE.
3
Press
ENTER again to input the information and move to
the next channel.
4
Repeat
1
,
2
and
3
for each speaker.
If you are using a Sound Pressure Level (SPL) meter
Take the readings from your main listening position and adjust
the level of each speaker to 75 dB SPL (C-weighted/slow
mode).
5 When you have adjusted each speaker level
and entered the information “Ch Level End”
will be selected. Press ENTER .
It will again take a moment as the MASTER VOLUME returns
to its original position.
6 Press ENTER again to return to go to the
“Crossover” settings.
Next, proceed to Crossover Network on the next page.
If you want to change a setting before proceeding
use the
5
/
∞
buttons (or the MULTI JOG dial) to go back.
memo
Î
SOURCE
ENTER
LOUDNESS
INPUT ATT
DIGITAL NR
FL DIMMER
REMOTE SETUP SYSTEM SETUP SIGNAL SELECT
TV VOL
TV
TVFUNC
D.ACCESS
BAND
GUIDE
MENU
CLASS
RETURN
MIDNIGHT
DSP
STEREO
FUNCTION
ADVANCED STANDARD
MUTE
S.MODE
CLEAR DTV INFO
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
/ DTS
RECEIVER DIRECT CONTROL
MPX
DTV ON / OFF
DTV MENU
CHANNEL
EFFECT/CH SEL
RECEIVER
TV CONTROL
MASTER VOLUME
DISC
+10
VIDEO SELECT
MULTI CONTROL
MULTI CH INPUT
DVD
CD
CD-R
TUN
TVC
RECEIVER
1
2
3
4
5
6
7
8
9
!
⁄
0
*
‹
&
2
TV
VCR
1
VCR
2
4
¢
¶
ENTER
TUNE
TUNE
ST
ST
4-6
THX
RDM
Note that it is also possible to set
channel levels temporarily. Then follow
the same procedure as explained on
this page. This function is designed to
be used when you want to change the
levels temporarily to raise the level of
one channel. Using this method you
can set speaker levels in different
modes, such as, STEREO, and each
DSP mode, independently. You should
return the settings to their original
state when done. Doing the set up
procedures on this page will erase any
temporary/independent level settings
that have been made.
